Filter
Top Products
13
V-AMP 2
For this application please select mode L1 or L2 under CONFIGURATION, depending on whether
you want to have the external amp with or without cabinet simulation! Thus, you can also
optimize the sound on the amp with TREBLE, MID and BASS of the global 3-band EQ.
2.5 Live set-up with P.A. system and your own monitor amp on stage
This application is intended to give you your own guitar signal on stage so that you can have complete control
of intentionally produced feedback, for example. The monitor amp is controlled via LINE OUT L including
additional 3-band EQ and effects, but no cabinet simulation. LINE OUT R feeds the DI signal to the P.A.
mixer. Here, the effects and cabinet simulation can be used without the 3-band monitoring EQ.
Fig. 2.4: Live set-up with P.A. system and on-stage monitor amp
For this application please select CONFIGURATION mode L3! You can adjust the sound on the
left channel for your stage amp independently using the global 3-band EQ.
3. V-AMP 2 PRESETS
The V-AMP 2 has 125 overwritable presets divided into 25 banks. In other words, there are five presets
available per bank. Each preset consists of a maximum of five “ingredients”:
V amp simulation (including GAIN, EQ and VOLUME settings),
V cabinet model (complementing the respective amp’s sound),
V pre-amp effects, such as noise gate, compressor, auto wah & wah-wah,
V post-amp multi-effects, such as delay and modulation effects and
V reverb/room simulations.
An overview of all the presets on the V-AMP 2 is enclosed with this manual.
3.1 Calling up presets
When the unit is switched on it automatically loads the preset used last. In the following example, the last
preset selected was preset D in Bank 25:
3. V-AMP 2 PRESETS