Filter
Top Products
10 SONIC EXCITER SX3040 User Manual
4.2.2 Connection with insert cables
Use standard ¼" insert cables to connect the SONIC EXCITER to the insert path of
a mixing console. These Y cables have two ¼" TS connectors at one end, and one
¼" TRS connector at the other. Connect the plug marked “Send” to the INPUT
L jack on the eects unit. Connect the “Return” plug to the OUTPUT L jack on
the device. Connect the TRS connector to the insert jack of the channel strip on
the mixing console. Use two insert cables for stereo sub-groups and main-mix
inserts. Thesecond cable must be connected to the INPUT/OUTPUT R jacks of
the SX3040.
strain relief clamp
sleeve
tip
sleeve
ground/shield
tip
signal
Return
(out)
strain relief clamp
sleeve
tip
sleeve
ground/shield
tip
signal
Send
(in)
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
ring
return (in)
tip
send (out)
Fig. 4.4: Insert cable with one ¼" TRS (tip-ring-sleeve) jack plug on one end andtwo ¼" TS
(tip-sleevel) jack plugs on the other end
5. Specications
Inputs
Connections XLR sockets and ¼" stereo jacks
Type Balanced
Input impedance 20 kΩ balanced, 10 kΩ unbalanced
Nominal input level +4 dBu
Maximum input level +22 dBu
Outputs
Connections XLR sockets and ¼" stereo jacks
Type Servo-balanced
Output impedance 60 Ω balanced, 60 Ω unbalanced
Maximum output level +22 dBu
Bass Processor
Type Frequency-selective compressor with
phase shifter
Filter cut-o frequency 50 Hz to 160 Hz
Sonic Exciter
Type Harmonic exciter
Filter cut-o frequency 1.3 kHz to 10 kHz
System Data
Frequency response 10 Hz to 120 kHz, ± 3 dB
Signal-to-noise ratio >90 dB, unweighted, 20 Hz to 20 kHz
Distortion (THD + N) 0.005 % typ. @ +4 dBu, 1 kHz (IN)
Crosstalk >90 dB
Power Supply
Mains Voltage
USA/Canada 120 V AC, 60 Hz
China/Korea 220 V AC, 50/60 Hz
Europe/UK/Australia 230 V AC, 50 Hz
Japan 100 V AC, 50-60 Hz
Export model 120/230 V AC, 50-60 Hz
Power consumption approx. 12 W
Fuse 100-120 V AC: T 250 mA, H 250 V
220-240 V AC: T 125 mA, H 250 V