Filter
Top Products
en
Control elements
5
Front panel
The 1 POWER switch is used to turn the power of the
BUGERA amplier on and off.
The 2 STANDBY switch allows you to place the amp
in STANDBY mode. This way the amp is idle, but the
operational temperature of the valves is maintained
(POWER switch turned on).
ATTENTION! TO AVOID DAMAGE TO YOUR
!
AMP, NEVER USE THE BUGERA VALVE AM-
PLIFIER WITHOUT A LOUDSPEAKER CON-
NECTED!
The 3 REVERB control determines the amount of the
built-in reverb effect. The 6262 (and 6262-212)
features individual REVERB controls for the LEAD
and CLEAN channels. The supplied footswitch lets
you activate the REVERB effect (see Chapter „Foot-
switch“).
The 4 PRESENCE control modies the amp’s damping
factor at high frequencies. This is used to ne-tune
the high-frequency range of the speaker cabinet.
The 6262 (or 6262-212) features individual PRES-
ENCE controls for the LEAD and CLEAN channels.
This is the 5 VOLUME control that lets you adjust the
volume level of the LEAD channel.
This is the 6 VOLUME control that lets you adjust the
volume level of the CLEAN channel.
The passive 7 TREBLE control adjusts the upper fre-
quency range. The 6262 (and 6262-212) features
separate TREBLE controls for the LEAD and CLEAN
channels.
The passive 8 MID control adjusts the middle fre-
quency range. The 6262 (and 6262-212) features
separate MID controls for the LEAD and CLEAN
channels.
The passive 9 BASS control adjusts the lower fre-
quency range. The 6262 (and 6262-212) features
separate BASS controls for the LEAD and CLEAN
channels.
This 10 GAIN control species the input level of the
LEAD channel. Turn the control to the right to in-
crease the preamplier’s distortion and sustain.
The 11 LEAD switch activates the LEAD channel (switch
glows red).
The 12 CRUNCH switch activates the gain boost on
the CLEAN channel (switch glows yellow). This way
the CLEAN channel can be used as a second LEAD
channel.
This 13 GAIN control species the input level of the
CLEAN channel. Turn the control to the right to in-
crease the preamplier’s distortion and sustain.
Please note that extremely high GAIN settings
$
in conjunction with extremely high VOLUME
settings can make the combo models vibrate
mechanically. This may occur when played at
extremely high volume levels, which is seldom
done. Should this be the case, adjust the GAIN
and VOLUME settings so that the problem does
not recur.
The 14 CLEAN switch activates the CLEAN channel
(switch glows green).
You can also activate both channels with the
$
supplied footswitch. Refer to „Footswitch“ for
details.
The 15 BRIGHT switch activates an extra boost in the
high-frequency range (+6 dB at 2 kHz) which only
affects the CLEAN channel.
The 16 LOW GAIN input is used for instruments with
an extremely high output level that could distort the
HIGH GAIN input (only 6260 and 6260-212).
The 17 HIGH GAIN input (6262 and 6262-212: IN-
PUT) is 6 dB louder than the LOW GAIN input and is
used for most electric guitars.
The HIGH GAIN and LOW GAIN connectors
$
have identical sensitivity when used at the
same time (both with LOW GAIN sensitivity).
Control elements
Front panel of the BUGERA 6260