Filter
Top Products
3. Place each mount-
ing base under the
Bazooka so that the
apex at the bottom of
the tube sits inside
the mounting base as
in figure7.
4. Move the bases so
that they are spaced
approximately 3”
from each end of the
enclosure as illustrat-
ed in figure 8.
5. Remove the Bazooka
without moving the
mounting bases and set
it aside.
6. Screw each mount-
ing base securely in
place with screws pro-
vided as illustrated in
figure 6.
MOUNTING THE BAZOOKA
7
4
Please take time to read through this manual and plan out your installation
before you begin!
Locate an area in the rear of the vehicle where you would like to place the
Bazooka speaker systems. The location you have selected must meet the follow-
ing requirements in order for the Bazooka to be properly installed in the vehicle:
Be sure that your application meets all of these requirements before you
continue the installation procedure!
INSTALLATION
1) The woofer (grill end) should be facing
into a corner. (See figures 1, 2 and 3)
2) Ideally, there should be 2 to 4 inches
between the woofer and the corner it is
pointing into.
3) The mounting area should be carefully
checked to be sure that the mounting
screws will not damage the gas tank,
electrical wiring, fuel lines, or the spare tire
during the mounting of the strap bases.
4) The strap mounting bases should be
screwed securely to a rigid surface that is
part of, or anchored to, the structure of
the vehicle.
Figure 7
Figure 8
3
,,
3
,,