Filter
Top Products
CONTENTS
PRACTICE SAFE LISTENING
System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 4,5
Mounting The Bazooka . . . . . . . . . . . . . . . . . . . . . . . . . .pg 6,7,8
Hooking Up The Bazookas To Power . . . . . . . . . . . . . . . . .pg 9
Technical Note . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 9,10
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 10
Continuous exposure to high volumes of sound may cause permanent hear-
ing loss. High powered auto sound systems are capable of producing
sounds well over 130 dB. Even short periods of play at high volume levels
can impair your ability to hear necessary traffic sounds and may constitute
a hazard. Please use common sense and practice SAFE LISTENING !
If you have any questions contact
the SAS Technical Support Department at:
Phone - (504) 272 7135 • Fax - (504) 272-9844
Email - tech@ sasbazooka.com • Website - www.sasbazooka.com
In Canada: (604) 988 2966
15049 Florida Blvd., Baton Rouge, LA. 70819
2
TECHNICAL NOTE
BAZOOKA POWER HOOK UP
On the back of all Bazooka Reference Series passive models you will find
a terminal cup with two 5 way gold binding posts, red being positive and
black being negative. Hook the positive speaker output from your ampli-
fier to the red positive terminal of the Bazooka. Hook the negative speak-
er output from your amplifier to the black negative terminal. Repeat these
steps for each Bazooka used.
9
Do You Have A Phase Problem?
If the bass response in your application appears to be lower then you
expected or sounds muffled and or distorted, you may be experiencing
Phase Cancellation.
Phase Cancellation
When two speakers in the same frequency range produce sound waves
that are inverted from one another or 180° out of phase, the sound
waves will cancel each other out to some degree. This effect will be
heard as a drop in the output level and/or a muffled or muddy quality
in the Bass Response.
The source of this Phase Cancellation can be at any point in the signal
path. The obvious cause of this problem would be a speaker connection
that was reversed in polarity, but that is not always the case. Sometimes
amplifier channels will shift phase 180° for no good reason, or a signal
processor could have a setting for phase that has been set incorrectly or
the source material could just be recorded in error. Also speaker place-
ment and the acoustics of the listening environment can effect the phase.
No matter what or where the cause is located, the solution is an easy one.