Filter
Top Products
Here is shown how to fasten
the loudspeaker with a ‘type 1
bracket’ to a Bang & Olufsen
‘single-column’ stand (or wall
bracket). Use the same
procedure if you wish to fasten
the loudspeaker to a Bang &
Olufsen ‘double-column’ Stand
– with a ‘type 2 bracket’
.
a Remove the small cover (if any)
on the stand. Press the cover as
shown, and it will come loose.
b Fasten the bracket to the stand or
wall bracket. Use the two longest
screws (M5 × 25 mm) – four
screws for a ‘type 2 bracket’
.
c Fasten the loudspeaker to the
bracket. Use the two shortest
screws (M5 × 8 mm). However, do
not fully tighten the screws before
you have made the adjustments
mentioned below (
d). Adjustments: First, make sure that
the television is adjusted to a level
position on its stand or wall bracket!
Then use the two screws (
d) to
adjust the loudspeaker so that it is
parallel to the lower edge of the
television. Align the loudspeaker
front with the television and tighten
the two screws (
c).
b c
c
d
d
c
c
a
5
NOTE! BeoVision 7 and its
accessories are not available on all
markets.