Filter
Top Products
4
GETTING TO KNOW YOUR
LX-18A V2 ACTIVE 18” SUBWOOFER
PANEL CONTROLS
11) Level Control: Sets the volume of the subwoofer
12) Phase Switch: Sets the polarity of the LX-18A V2.
13) Power Indicator: The Power indicator lights when the LX-18A V2 amplifier
has been turned on and has power.
14) Protection: Red LED turns on when distortion is audible in the
amplifier output. This indicates that you should turn the amplifier down.
15) Right & Left Inputs: These inputs are summed and sent to amplifier’s
Low Pass filter (120 Hz and below).
16) Right & Left Full-Range Outputs: Send stereo full-range signal
allowing daisy chaining of additional subwoofers. You do not need to
y-cable out of your mixer or audio device to get an additional full-range signal.
17) Right & Left High-Pass Outputs: Send stereo high-pass signal (120 Hz and
above) directly to active, full-range speakers or through a rack-mount amplifier
to passive speakers.
18) External Speaker On/Off Switch: Turns Speakon NL-4 connector (and external
subwoofer) on and off. When only using the LX-18A V2, turn this switch off.
When an external, non-powered subwoofer (LX-18 V2) is connected, turn this
switch on. NEVER turn switch on or off while amplifier is at full volume.
19) External Speaker Output: The Speakon NL-4 connector connects the amplifier
to an external, non-powered subwoofer (LX-18 V2). Either pins 1+ and 2+ can
be used as the positive connection. Either pins 1- or 2- can be used as the
Negative Connection. External subwoofer must be 8 Ohms
10) ON/OFF Switch: Turns the LX-18A V2 amplifier on or off. The LX-18A V2
will only turn on when the amplifier detects an audio signal.
11) Fuse Holder: Houses a fast-resetting 12 amp fuse.
12) Power Cord Connector: For attachment of the included power cord.