Filter
Top Products
To change the remote control handset to operate the CX-7e
MP
,
simply press the number button “7” five times in succession.
(Please note that the “Audio” button used to select soundtracks
on DVD discs will have no function in this configuration.) Press
the number button “8” five times in succession to change the
remote handset to operate the DX-5. To return the remote
handset to operate the C-5xe
MP
again, press the number button
“5” five times in succession.
To ascertain the current configuration of the remote control
handset, press the number button “0” five times in succession.
The backlight illumination will flash five times to indicate that it
is configured to operate the C-5xe
MP
, seven times to indicate
that it is configured to operate the CX-7e
MP
, or eight times to
indicate that it is configured to operate the DX-5.
Trigger Control
A trigger control allows one component to control the
“Standby” state of another component. If there are no AyreLink
source components available to control the operation of the
KX-R preamplifier, it may be convenient to use the trigger
control from a source component.
The trigger signal from a source component will directly
control the KX-R preamplifier. The KX-R can then in turn
control amplifiers linked by the AyreLink communications
system. Connect the AyreLink ports of your components in a
daisy-chain fashion as described in the chapter “Connections
and Installation” with the KX-R at one end of the chain. The
unused AyreLink port on the preamplifier is then used as a
trigger input.
25