Filter
Top Products
low setting. After that, the current volume setting is
retained in memory, and will remain constant when
changing inputs.
Input Source Selection
The source component may also
be selected with the remote
control.
The input selector buttons are located below the
display. Icons that match the connector labels on the
rear panel (Star, Planet, Comet, Moon) are used to
denote the inputs. When the unit is first connected
to an AC power source, the “Star” input is selected
by default.
The input selector utilizes sophisticated FET
switches. Both the signal and ground connections to
each source component are switched, so that any
un-selected components are completely disconnected
from the system. This avoids any problems with
undesired ground loops.
7
A y r e
K-5x