Filter
Top Products
128-6374A
6 of 12
DIRECTLY ACCESSING A CHANNEL
This section describes the procedure used to directly access a specific
channel, this is different then making direct access in Category mode
(see SELECTING CHANNEL CATEGORIES)
1. With the system powered up, momentarily press the Shift (SFT)
button causing the first channel number in the current category to
flash for 5 seconds. The flashing number indicates the Channel
number in Channel mode.
2. While the number is flashing, use the number buttons on the
keypad to enter the channel desired. The selected channel
number will flash for 5 seconds and then remain steady.
The flashing number indicates the value of the Category in
Category mode.
NOTE: If the selected channel is not available within the band, a “In-
valid Channel” message will appear on the display and the system will
remain tuned to the previous channel.
6
NOTE: When an invalid (no broadcast) channel is encountered, the
channel is automatically skipped.
A typical channel display will appear as shown below.
Confirmation Tone(s) Function
There are two basic functions of this feature; the Command Confirmation
Tone, the Station Pre-Set Program Confirmation Tones. The following is
a description of each of these functions:
1. Command Confirmation Tone - This function utilizes a single
High Tone signal that is heard each time a button is pressed to
confirm that the command was executed. This tone is imple-
mented each time the user presses the Power, Mute, Scan,
Shift or Directional (
WXWX
WXWX
WX) button(s) as well as for each of the
numbered buttons.
2. Station Pre-Set Program Confirmation Tones - This function
utilizes two High Tone signals that are heard each time the user
programs a Pre-Set channel. When the user enters a channel
into memory (Refer to Presetting A Desired Channel below) a
High Tone will be heard as the selected number button is
pressed and held. A second High Tone Signal is heard con-
firming that the Pre-Set command was executed. It is only after
the second tone that the user can release the button (approxi-
mately two seconds).
Figure 5. Sample SIRIUS
®
Display
USING THE UP/DOWN BUTTONS
This section describes two ways the Down (
WW
WW
W
) and Up (
XX
XX
X
) directional
buttons are used to select an SIRIUS® channel. Proceed as follows:
1. To advance one channel at a time in the chosen direction (Up or
Down), momentarily press and release either directional
button (
WXWX
WXWX
WX
) until a desired channel is reached.
2. To advance rapidly in the chosen direction (Up or Down), press
and hold either directional button (
WXWX
WXWX
WX
)
.
Release the directional
button when a desired channel is reached.
CATEGORY (only in Category Mode)
CHANNEL
NAME
SONG TITLE
ARTIST
NAME
CHANNEL
NUMBER
PRESET GROUP INDICATOR
SR1 -or - SR2
PRESET CHANNEL
Figure 6. Using the UP / Down Buttons
MOMENTARY PRESS:
ADVANCE UPWARD ONE
CHANNEL AT A TIME
PRESS AND HOLD:
CONTINUOUS ADVANCE
UPWARD
MOMENTARY PRESS:
ADVANCE DOWNWARD
ONE CHANNEL AT A
TIME
PRESS AND HOLD:
CONTINUOUS ADVANCE
DOWNWARD