Audiovox Satellite Radio Receiver Satellite Radio User Manual


 
-14-
FM Frequency
The following Frequency Setting adjustments are possible:
NOTE: The Xpress XM7 unit has an internal wireless FM trans-
mitter, which allows you to play the audio through any standard
FM receiver, eliminating the need for hardwire connections. In
certain urban areas of the country where strong FM stations
may overpower the Xpress XM7 unit FM transmitted signal, an
FM direct adapter may be needed to achieve a clean audio
signal (Part Number XMFM-1)
FM ON or OFF Feature
This feature allows the user to turn the FM Transmitter ON or
OFF. It is recommended that you turn the FM Transmitter OFF if
you are using the low level audio outputs in your particular
application (optional cable needed SAT-RCA) (see Figure 7).
Upon entering the “FM Frequency” mode the FM transmitter will
be OFF by default. To turn the FM Transmitter ON, turn the
Rotary/Select knob CW/CCW or use the UP and DOWN buttons
on the Remote Control to the highlight the desired frequency
(88.1, 88.3, 88.5,.......107.9).
Figure 7. FM OFF Screen
The selected frequency must be an unused frequency or a
frequency used by a low powered FM station in your area. If
not, the strong signal from the FM station may overpower the
Xpress XM7 unit FM transmitted signal which may result in
interference.
With the FM Frequency highlighted, press the Rotary/Select
Knob or the (XM) Select button on the remote control to confirm
the selection (see Figure 8).
Figure 8. FM Frequency Screen