Filter
Top Products
INSTALLATION INSTRUCTIONS
INSTALLATION DIAGRAM
1. Select a mounting area where the amplifier will
have sufficient air circulation for proper cooling.
Inadequate air circulation will cause the
temperature of the amplifier to rise and will
trigger the thermal protection mode.
2. Place the amplifier on the mounting surface and
mark the locations of the four mounting holes as
shown in the illustration.
3. Remove the amplifier and drill a 1/8" hole at each
of the four locations.
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION: Before drilling the holes, look at the
underside of the mounting surface. Always
check carefully to avoid drilling into wiring,
braces, fuel or brake lines.
CHECK BEFORECHECK BEFORE
CHECK BEFORECHECK BEFORE
CHECK BEFORE
YOU DRILL !YOU DRILL !
YOU DRILL !YOU DRILL !
YOU DRILL !
4. Apply a self-adhesive rubber washer to the
bottom of the amplifier at each of the 4 screw
locations. Secure the amplifier to the mounting
surface using the self-tapping screws provided.
5. Attach the plastic end panels to the amplifier by
removing the protective paper from the self-
adhesive strips on the bottom of the panels and
pressing them into position on the amplifier.
-3-
MOUNTING SURFACE
1/8" DIA.
HOLE
SELF-TAPPING SCREW
END PANELS
RUBBER WASHERS