Filter
Top Products
-9-
CD PLCD PL
CD PLCD PL
CD PL
AA
AA
A
YER ERRYER ERR
YER ERRYER ERR
YER ERR
OR CODESOR CODES
OR CODESOR CODES
OR CODES
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel.
This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure
it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button dm on the unit, but this
will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
1. Switch the vehicle ignition and radio “on”.
2. Press the Time/Frequency (T/F) button to call the time display.
3. While holding the T/F button in, press the Down TUNE/SEEK/TRACK ( ) button to adjust the hours and AM/PM indication,
or the Up TUNE/SEEK/TRACK ( ) button to adjust the minutes to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the
normal indication.
SETSET
SETSET
SET
TT
TT
T
ING THE CLOCKING THE CLOCK
ING THE CLOCKING THE CLOCK
ING THE CLOCK
NOTES ON USE OF REMOTE INPUT JACK:
The remote input jack provides the user option of applying an external audio source to the radio.The audio jack is compatible with most
"Walkman" CD and cassette players, or an MP3 digital audio playback unit. When the external source is connected, only that media
is played by the radio; no other input sources (radio or CD) are operative.