Filter
Top Products
SETTING THE CLOCK
1. Turn the radio on so that the radio frequency or clock time is shown on the display panel.
2. Press and hold the Select button 3 approximately 4 seconds until the time display begins flashing.
3. While the time display is still flashing, press the Manual Down Tuning button ( ) to adjust the hours and the Manual Up Tuning
button ( ) to adjust the minutes to the correct time.
4. When the correct time is shown on the display panel, press the Select button 3 again to return to normal display.
-7-
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel spacing on AM, 200 KHz.
spacing on FM). Use in other areas of the world may require different channel spacing. A switch on the bottom of the chassis allows
selection of 9 KHz. AM/50 KHz. FM channel spacing. With the 16-pin power connector un-plugged from the socket at the rear of the
chassis, slide the switch to the appropriate position using a small screwdriver blade.
ERROR CODES
If a problem should develop while operating the CD player, the following error codes may be displayed on the LCD panel.
In case of any of the above indications, eject the disc, make sure it clean, undamaged, and had been loaded correctly (label side up).
Re-load the disc and check for proper operation or try another disc. If this does not solve the problem, contact an approved warranty
station for further assistance.
Indicates an error in the unit reading the data
on the disc.
Indicates an error in the laser focus on the
disc.
Indicates a data and focus error.
Indicates a mechanical error.
E-01:
E-02:
E-03:
E-04: