Filter
Top Products
-2-
pressed to decrease the volume quickly. The display will
automatically return to the priority indication 5 seconds after the
last volume adjustment or when another function is activated.
This button is also used in conjunction with the Select button 3
to adjust the bass, treble, balance, and fader levels as described
in 4, 5, 6 and 7.
3 SELECT BUTTON (SEL)
DISPLAY CALL
DISPLAY PRIORITY SELECTOR
IGNITION-OFF CLOCK CALL (CLK)
This button is used to select the audio function (volume, bass,
treble, balance, or fade) to be adjusted using the Level Control 2,
as well as the indication (time or frequency/cassette/disc) shown
on the display panel. Momentary presses of the button will change
the display from radio frequency/cassette/disc indication to clock
time. After 5 seconds, the display will automatically return to the
priority setting.
During CD changer operation, a momentary press of the button
will change the display from disc/track number to CD track elapsed
time. Another press of the button will change to clock time.
After 5 seconds, the display will automatically return to disc/track
number if set to CD track display priority. If the unit has been set
to clock time display priority, momentary presses of the button
will change the display to CD disc/track number and then CD
elapsed time. After 5 seconds, it will change back to clock time
display. If the unit has been set to elapsed time priority, momentary
presses of the button will change the display to clock time and
then CD disc/track number.
Additional momentary presses of the button will set the unit for
bass adjustment (level number above “BAS” will flash on display
panel), treble (level number above “TRE” will flash), balance (“BAL”
on display), fader (“FAD”) or volume (level number). The display
will automatically return to the normal indication 5 seconds after
the last adjustment is made or when another function is activated.
This unit can be set so that the radio frequency/cassette/disc
indication (factory setting) or clock time will appear on the display
panel as the priority setting. To change the priority setting, press
and hold the Select button for 2 seconds until the display changes
to the next indication. That indication will now be the priority
setting and the display will automatically return to that indication
after any radio, cassette, disc or audio function is displayed.
NOTE: When changing the display priority setting, release the
button as soon as the display changes (approximately
2 seconds). Holding the button in for too long will put the
unit into time setting mode (flashing time display). See
section on “Setting the Clock”.
To check the time with the vehicle ignition switch in the “off”
position, momentarily press the Select button. The display will
illuminate and show the time and then automatically shut off after
5 seconds.
4 BASS CONTROL
To adjust the bass level, first select the Bass mode by pressing
the Select button 3 so that the level number above the “BAS”