Filter
Top Products
Page7 of 10
P/N 8007131
Rev. C 1/12/99 BJ
Step 3) Install console to floor of vehicle.
⇒ BEFORE DRILLING ANY HOLES VERIFY THAT THE DRILL BIT WILL NOT
ENTER INTO THE FRAME RAIL(S) OF THE VEHICLE, ELECTRICAL WIRES,
FUEL LINES, BRAKE LINES, HOSES, EXHAUST SYSTEMS OR ANY OTHER
ITEMS THAT WILL IMPAIR THE OPERATION OF THE VEHICLE. THE BOLTS
OF THE FLOOR CONSOLE MUST SECURE TO THE FLOOR PANEL OF THE
VEHICLE. CLIMB UNDER THE VEHICLE AND LOOK TO VERIFY THAT THE
HOLES WILL BE IN THE PROPER LOCATIONS.
⇒ Set the console on the floor and of the vehicle and mark where the holes are to
be drilled. Drill small 1/8” pilot holes to verify that the drill holes are in the
proper locations.
⇒ After verifying that the 1/8” pilot holes are in the proper locations, use the ¼” drill
bit to widen out the 1/8” pilot holes.
⇒ Set the console on the floor over the vehicle.
⇒ Place the bolts through the feet of the console and into the holes just drilled.
⇒ Place one large fender washer and one lock washer over each of the bolts and
attach the nuts.
⇒ Tighten the nuts down securely. Have the second person inside the vehicle hold
the bolts securely while the person underneath the vehicle tightens down the
nuts.