Filter
Top Products
Page2 of 10
P/N 8007131
Rev. C 1/12/99 BJ
This manual contains specific instructions on how to install this automotive TV/VCP
floor console. Please read this manual thoroughly before installing the console into
the vehicle.
**WARNING**
In order to maintain a safe mounting system, this console MUST be secured to
the floor of the vehicle according to the instructions contained in this manual.
Failure to do so may result in the console becoming a projectile in the event of
an accident.
It is unlawful in most jurisdictions for a person to drive a motor vehicle which
is equipped with a television viewer or screen that is located in the motor
vehicle at any point forward of the back of the driver’s seat, or that is visible,
directly or indirectly, to the driver while operating the vehicle. This product
should only be installed to the rear of the back of the driver's seat where it will
not be visible, directly or indirectly, to the operator of the vehicle.
Required tools for installation:
Electric drill
¼” steel drill bit
1/8” steel drill bit
Phillips screwdriver
Socket wrench set with size 7/16” socket
Box end wrench size 7/16”
Soldering Iron
Two people are required for installation
QTY
0892110 Bracket Kit 1
8007101 Bracket 4
8007105 Screw, hex #8x3/4” self-drilling 20
8007106 Washer, 3/16” 20
8007112 Strap, open 55.75”, nylon 1
8007113 Strap, loop 45.75”, nylon 1
8007125 Bolt, ¼”x1 ½”, hex 4
8007126 Washer, fender 5/16” 4
8007128 Nut, nylon insert 5/16” 4
8007131 Installation manual 1
8051005 Poly bag 5x9 1