Filter
Top Products
of that disc will continue ("SCAN" and "DISC" will disappear from the
display). Disc Scan mode will also be cancelled by activating any other
function (Repeat, Shuffle, Disc Select, Track Skip, or Track Search).
bl REMOTESENSOR
The sensor for the infrared signal from the optional wireless remote
control is located behind this lens. For optimal operation of the remote
control, keep the lens clean and do not allow objects to block it.
bmRESETBUTTON
A reset button is located on the front panel of the remote control which
must be activated with a pen or other thin object as it is recessed to
prevent accidental engagement. The reset circuitry is provided to
protect the unit's microprocessor and laser pick-up system and should
only be activated under the following circumstances:
1. Initial installation after all wiring is completed (this must be done).
2. If abnormal disc operation is encountered, the reset button may
be pressed to clear the system and return to normal operation.
IMPORTANT: Use of theReset button on the CDChanger will cause the
CD magazine to be automatically ejected. Make certain
changer door is fully opened prior to using Reset.
CAUTION: When the CD magazine is ejected by the use of the Reset
button, whichever disc was in play prior to depressing Reset
may be left in the play position in the changer. It is critical
that before re-inserting the CD magazine, you must RE-
MOVE ALL DISCS from it. After you have inserted the
empty CD magazine, press the "EJECT" button on the
changer and the "in play" disc will be loaded into the empty
magazine. You may then remove the magazine and re-load
as many discs as desired.
WARNING: Avoid use of Reset buttons after initial use unless you have
a definite abnormal disc operation. Use the EJECT button
on the changer to remove the CD magazine for normal
operation.
5 - 20,000 Hz. ±1 dB
0.008% @ 1 kHz.
95 dB
95 dB
80 dB @ 1 kHz.
below measurable limits
88.7/89.1 MHz. (switchable)
11-1/2"W x 3-5/8"H x 7-1/2"D
291 mm x 92 mm x 190 mm
4-3/4"W x 1-5/8"H x 5/8"D
120mmx40mmx17mm
12 volts DC, negative ground
Frequency Response:
Distortion:
Dynamic Range:
Signal-to-Noise Ratio:
Channel Separation:
Wow & Flutter:
Output Frequency:
Dimensions:
Changer:
Control Unit:
Operating Voltage:
FM Modulator:
Changer:
General:
SPECIFICATIONS:
7
ERROR SIGNS:
If a problem should develop while operating the CD changer, the
following error signs may be displayed on the LCD panel:
E-01:
E-30:
- - --:
0-00:
1--- :
Indicates abnormal disc change function. Contact the place of
purchase for further service advise.
Indicates excessive temperature conditions. The error sign will
go off and play will resume when the changer temperature
returns to normal range
Magazine is not loaded in the changer.
No discs are loaded in the magazine.
No disc is loaded in magazine slot #1. (2---- indication for slot
#2, etc.)