Filter
Top Products
99
99
9
IMPORTANT
AMOUNTINGKITISREQUIRED
FORTHISINSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATION
ALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCEALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCE
ALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCEALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCE
ALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCE
19741974
19741974
1974
Important-This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth vehicle without an
installation kit. Refer to the Kit Listing on Page 2 for the required kit. Complete kit installation is explained in the
instructions included with the kit.
1. Remove ExistingRadio:1. Remove ExistingRadio:
1. Remove ExistingRadio:1. Remove ExistingRadio:
1. Remove ExistingRadio:
A. Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured by
screws and/or snap-in clips.
B. Remove the two large screws used to secure radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Installthe NewRadio:2. Installthe NewRadio:
2. Installthe NewRadio:2. Installthe NewRadio:
2. Installthe NewRadio:
A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with
the kit.
B. Place the radio near the dashboard so the wires can be led through the opening and following the instructions
of Step 2 on Page 3, carefully wire the radio making certain all connections are secure and insulated and
confirm proper operation.
C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the other endof the perforated strap toa secure part of thedashboard either above or below
the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the
weight of the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.
HEXNUT
PERFORATEDSTRAP
SCREWSTUD
RADIO
EXISTINGDASHTRIMPANEL
SCREW
SHAFTNUT
HEXNUT
MOUNTINGPLATEFROMKIT
(NOTINCLUDEDWITHRADIO)
1-800-645-7102
HELP!
Monday-Friday
Saturday
8:30am-7:00pmEastern
9:00am-5:00pmEastern
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATION