Filter
Top Products
increase the output from the system. If, however, there
is still output from the amplifier when the car stereo
volume control is at its minimum setting, or the output
level increases too fast with a small rotation of the volume
control, adjust the Gain control to decrease the output
from the system. Once the correct setting is found, these
controls should not require any further adjustment.
3 Fuse
The circuitry of the amplifier is protected from damage by
an automotive-type fast-blow fuse. If fuse replacement is
necessary, use only fuses of the same ampere rating as
originally supplied with the unit. The use of fuses with
incorrect ratings may cause serious damage to the
amplifier. If fuses blow consistently, carefully check all
electrical connections to the unit.
-8-
OPERATION
After initial set-up, the amplifier should not require any
further adjustment unless there is a change in the car
stereo or speaker system with which it is used.
1 Power Indicator LED
The Power Indicator LED will illuminate to indicate that
the unit is connected to the battery and that the
Remote Turn-On terminal is receiving +12 volts, thus
turning on the amplifier.
2 (Gain) Controls
The amplifier is capable of operating from sources
supplying a wide range of input levels. The Gain control
should initially be set to the mid-rotation position. If it is
found that there is not enough output even when the
volume control on the car stereo is at its maximum setting,
adjust the Gain control of the respective channels to
1
2
3
2