Filter
Top Products
88
88
8
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
prevent it from being accidentally damaged
( will appear on the display panel to
indicate that a disc is loaded in the player).
Play of the disc can be resumed by using
the Function Mode Selector cm to choose
CD player function.
NOTE: To prevent an ejected disc from
accidentally being damaged, always
remove the disc from the unit. Do
not leave the disc extending from
the disc slot.
bq FRONT PANEL RELEASE BUTTON
(REL)
This button is used to release the mechanism
that holds the front panel to the chassis. To
detach the front panel, press the button so
that the panel releases form the chassis.
Grasp the panel at the middle and pull it off
of the chassis.
To re-attach the panel, press the left side of
the panel in place first (left facing radio) and
then press the right side of the panel until
the mechanism locks it into place.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-
side-up when attaching it to the chassis
as it cannot be attached when up-side
down.
2. Do not press very hard on the front
panel when attaching it to the chassis.
No more than light to moderate pressure
should be needed.
3. When attaching the front panel, make
sure it is centered in the chassis frame
and is pressed straight into position.
4. When taking the front panel with you,
please use the supplied carrying case to
protect the panel from dirt and damage.
Make sure there is no dust or dirt on
the electrical terminals on the back of
the panel as this could cause
intermittent operation or other
malfunctions.
br THEFT-DETERRENT L.E.D.
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is removed. The flashing
light serves as a visual warning to the
would-be thief that the unit has been disabled
by removal of the front panel.
bs RE-SET BUTTON
A Re-Set button is located on the front of the
chassis (front panel must be removed to
access the button). The re-set circuitry is
provided to protect the microprocessor
circuitry and should only be activated under
the following circumstances as it will erase
the time and pre-set memories.
1. Upon initial installation after all wiring
is completed.
2. If there is a malfunction of any of the
switches on the unit, pressing the Re-Set
button may clear the system and return to
normal operation.
bt MANUAL TUNING CONTROL
Turn this knob clockwise to tune upward in
frequency on the band in use, counter-
clockwise to tune downward in frequency.
The frequency to which you are tuned will be
shown in digital form on the display panel.
When tuning in a station, always adjust