Filter
Top Products
For use as a dedicated subwoofer channel, set the filter switch to the "LPF" (Low Pass Frequency).
Adjust the variable crossover frequency with control knob as desired. The amplifier input circuit filters out
everything above 50Hz ... 150Hz (dependant on the adjustment of the frequency control), so only the
lowest bass notes are amplified.
The sub sonic control will cut all frequencies below what it is set to from going to your sub(s). This will
prevent your subs from playing any frequencies that may harm them.
7. Low-Pass Filter Control
8. Sub Sonic Control
9. Bridged Connection
10. Light Switch
This is the connection used to bridge 2 two of the same class D amplifiers together. Later in this manual it
is explained how to bridge the amps and what settings to use.
This switch is used to tun the extrnal lights on and off. When set to the off position, only the
power/protection lights, volt-meter and clipping lights will stay on.
CONTROLS & FUNCTIONS
8