Filter
Top Products
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3332 • FAX: (800) 765-3435
©2004 ATLAS SOUND LP Printed in U.S.A. ATS001856 RevA 7/04 PP
INSTALLATION INSTRUCTIONS
AH5040CD INSTALLATION
SPEAKER CABLE RECOMMENDATIONS AND CONNECTION INSTRUCTIONS
Wire Gauges (8-ohm operation)
For very short distance speaker cable runs (less than 25') #16-Guage, stranded, twisted pair speaker
cable may be used. For speaker cable runs between 25' and 75', #14-Guage, stranded, twisted pair
speaker cable is recommended. For speaker cable runs greater than 75' #12-Guage, stranded, twisted
pair speaker cable is necessary.
The AH5040CD uses (2) Speakon
TM
NL-4 connectors. Both connectors are paralleled with pins 1+ and
1- as the speaker input. Pins 2+ and 2- are paralleled to allow "daisy chaining" to other AH5040CD’s.
Check the labeling on the Speakon cable connectors for the Speakon wiring diagram.
The figure below shows the location of the access holes for the Speakon connectors.
The connection wiring should be routed through the access holes (as shown above) and attached to the
Speakon connectors. Allow an adequate service loop for this connection to allow tilt of the loudspeaker.
Weep-holes (for drainage) are located on the same side as the input connectors. If the speaker is
tilted above parallel to the ground, the speaker should be installed with the weep holes down for water
drainage.
D
C
B
A
A
B
C
D
123
45
6
7
8
8
7
6
5
4
3
2
1
E
F
E
F
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
MITEKCO
RP. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
MITEKCORP IS
PROHIBITED
.
PROPRIETARY AND CONFIDENTIAL
MODEL
SIZE
SCALE
AH5040CD
1:8
C
ATLAS SOUND
A MITEK CO
MPANY
1601 JACK McKAY BLVD.
PH:972-875-8413 FAX:972-875-8416
ACCESS HOLES FOR
SPEAK-ON CONNECTORS
HOLE FOR
STRAIN RELIEF