Filter
Top Products
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3332 • FAX: (800) 765-3435
©2004 ATLAS SOUND LP Printed in U.S.A. ATS001856 RevA 7/04 PP
INSTALLATION INSTRUCTIONS
AH5040CD INSTALLATION
MOUNTING
CAUTION: Mounting the AH5040CD requires two people, unless it is possible to safely clamp the
speaker in position for alignment before mounting.
The bracket may be removed from the AH5040CD for installation convenience. When re-attaching
speaker to bracket be sure to tightly secure speaker mounting bolts. Thread locking compound should
also be used in this operation.
1. Choose the bracket mounting holes best suited for the surface you are mounting to. For best
stability the 5/8" (16mm) diameter outer keyhole slots @ 12-1/8" OC spacing are recommended.
When using these mounting holes 1/2" (grade 5 hardware minimum) hardware should be used
with proper flat and lock washers. Remember to use thread- locking compound on all parts.
2. Use the dimensions noted on the above illustration to mark the points where the starting hole
should be drilled.
3. Choose appropriately sized bit and drill holes.
4. Attach speaker bracket, using bolt, flat washer, and lock washer as shown and re-attach
loudspeaker to bracket.
5. Secondary (safety) suspension point: Use a load rated cable or steel chain (capable of holding
the speaker should it come loose from the primary mounting point). This cable or chain assembly
should be attached to at least (2) of the drop forge eyebolts provided on the AH5040CD and
secured to the mouning surface via approved, load rated hardware.
20.25
23.75
BOTTOM VIEW
FRONT VIEW
TOP VIEW
27.97
SIDE VIEW
21.41
BACK VIEW
8.75
12.13
5.00
2.75
D
C
B
A
A
B
C
D
123
45678
8 7 6 5
4
3
2 1
E
F
E
F