Filter
Top Products
5
Instruction Manual
Connecting Your Subwoofer
Connecting Your Subwoofer
Use the low-level (RCA jack) subwoofer line out of your surround sound
receiver/processor. Simply connect your subwoofer with a high quality
shielded cable as shown in the diagram on page 7. Please consult your
processor/receiver manual for further information.
WARNING:
To prevent risk of electrical shock or damage to your
equipment, always unplug all component AC cords before pro-
ceeding with speaker and component connections! The last step in
wiring your system should be plugging in the AC cords!
Subwoofer Line Out to Low Level In
Run an RCA cable from your receiver’s Sub Out jack to the L/Mono input
jack on the back of the subwoofer (Figure 3). If your receiver/processor
has stereo subwoofer outputs, connect these to both the L/Mono and R
jacks on the back of the subwoofer (Figure 4).
Using the Low Level Output
If desired, you can run a low level signal through the subwoofer and out
to another unit. This way you can add an additional subwoofer with mini-
mal additional wiring. The signal that comes out of the output jacks is
identical to the input signal.
Power Connection
Connect the power cord to an AC outlet
only after making all other connections
to the subwoofer. This will avoid any
chance of accidentally activating the
subwoofer while wiring. Atlantic Tech-
nology does not recommend plugging
the subwoofer into the switched outlet
of an amplifier, preamplifier, or receiver. The power demands of the sub-
woofer amplifier may exceed the power rating of the switched outlet and
may damage the equipment.
Figure 2
AC Connection
Your subwoofer is totally automatic in its operation. The automatic on/
off circuitry will only activate the subwoofer in the presence of an audio
signal from your system. After 7-10 minutes with no signal detected from
the rest of the system, the amplifier will shut itself off and go back into
standby mode. When the sub is in operating mode, the status LED will
glow green. The LED will glow amber in the Standby mode and power
consumption in this mode is negligible. Standby operation can be com-
pletely bypassed by placing the standby switch on the rear panel to the
ON position.
BYPASS
LOW-PASS
ON
AUTO
PHASE
NORMAL
INVERT
40
160
100
LOW-PASS
60
RIGHT
L/MONO
OUTPUT
INPUT
STATUS
ON OFF
AC INPUT
50-60Hz 300W MAX
220-240V110-120V
FOR 110-120VAC, USE 2.5AL 250V FUSE
FOR 220-240VAC, USE 1.25AL 250V FUSE
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
U.S. Patent #5,075,634 and
5,510,753 Patent Pending
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DOUBLE INSULATION - WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT PARTS
A
Z
A
R
D
S
S
S
E
COMPLIANT
E
S
R
H
I
O
T
R
I
C
T
N
O
F
O
U
C
B
S
T
A
N
U