Filter
Top Products
20
Center of Screen - Mixer
Controls the connections between source and destination
lines. To change a connection, click and hold on the
source channel button of the connection you wish to redi-
rect. Drag the pointer to the new destination channel but-
ton and release the mouse button (you will see a line as
you move across the mixer screen).
Bottom Right of Screen
Displays driver status and errors.
PROBLEMS RUNNING THE DEMO
Symptom: The screen appears to be frozen.
Solutions:
1. Verify that the driver is loaded.
2. Make sure you type the correct I/O and interrupt
locations on the command line of ADG.
3. Make sure to use the HEX value for the I/O.
4. Make sure syntax of ADG line is correct.
5. Make sure the I/O and interrupt of the Z1/Z1e/
SX-3/SX-33/SX-33e are not conflicting with
other system hardware.