Filter
Top Products
MADE IN USA
SIX YEAR WARRANTY
AN-130+ Speaker Monitor Owners Manual
2
BACK PANEL OF AN-130F1+
BASIC SYSTEM OPERATION
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
The AN-130+ monitor is used to amplify the signal
from a microphone, electronic musical instrument or
line-level sources
(MP3, iPod, CD, VCR, etc).
You’ll need a connection cable and an AC outlet.
1. Place the AN-130+ in desired location
2. Set volume control on front of speaker to
minimum
3. Plug the power cord into a grounded 115 volt
outlet
(220 volt outlet for export model)
4. Plug a microphone into the MIC input jack, or an
audio source into a LINE IN jack
5. Turn the power switch on the rear panel “ON”
(red LED on front panel should light)
6. Adjust the volume, bass & treble controls to
desired levels
NOTE: SEE PAGE 4
FOR WIRELESS RECEIVER
INSTRUCTIONS
MIC IN
An unbalanced, low impedance
microphone input is for use with the
MIC-90P or other mics that have a 1/4”
phone plug.
LINE IN
The line-level input jacks may be used with audio sources such as computers,
iPods or portable audio players.
LINE OUT
The unbalanced Line-out provides a combined signal of all inputs being used.
You can use this function to record your presentation or to “daisy chain” another
powered sound system to the AN-130+ for greater crowd coverage.
Note:
This output is post source level; any volume fluctuations for a specific input
will affect the output signal level at this output.
POWER SWITCH
POWER CORD