Filter
Top Products
Ampeg reserves the right to change specifications without notice.
Ampeg is proudly Made in America. ©2003 SLM Electronics, 1400 Ferguson Avenue, St. Louis, MO 63133 U.S.A.
P/N 47-617-51 • 091103
Technical Specifications
OUTPUT POWER RATING 1600 Watts Mono-Bridged @ 4 Ohms (1200 Watts Continuous)
1200 Watts Mono-Bridged @ 8 Ohms (900 Watts Continuous)
2 x 900 Watts @ 2 Ohms (600 Watts Continuous)
2 x 625 Watts @ 4 Ohms (490 Watts Continuous)
2 x 350 Watts @ 8 Ohms (300 Watts Continuous)
FREQUENCY RESPONSE -3dB @ 25Hz and 50kHz
TOTAL HARMONIC DISTORTION 5% @ full power
SLEW RATE > 30V/µs (stereo)
SIGNAL TO NOISE RATIO > 90dB typical
INPUT IMPEDANCE 220k ohm
INPUT SENSITIVITY 0.5V RMS
DAMPING FACTOR > 300
OUTPUT CONNECTIONS (2) 1/4” phone jacks, (1) Speakon
®
per channel; (1) Speakon
®
for Mono Bridge
PROTECTION CIRCUITRY Over-temp and Current Limited
COOLING Internal fan
POWER REQUIREMENTS 120VAC, 60Hz, 1.4kVA
100/115VAC 50/60Hz, 1.4kVA
240VAC, 50/60Hz, 1.4kVA
SIZE AND WEIGHT 19/17.4”W x 5.6”H (with feet) x 15.5”D; 39 lbs
SVP1600 Stereo Bass Power Amplifier
www.ampeg.com
Declaration Of Conformity
#32, Effective 01-01-2001
Manufacturer’s Name: SLM Electronics
Production Facility: 1901 Congressional Drive, St. Louis, MO 63146, USA
Production Facility: 700 Hwy 202 W, Yellville, AR 72687, USA
Shipping Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Office Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Product Type: Audio Amplifier
Complies with the following Standards:
Safety: EN60065, E60065, C22.2, UL6500 and/or UL813
EMC: Directive 89/336/EEC, EN55103, EN55013, EN61000,
and/or FCC 47CFR 15B clA
Supplementary information provided by:
SLM Electronics - R & D Engineering
1901 Congressional Drive, St Louis, MO 63146, USA
Tel.: 314-569-0141, Fax: 314-569-0175