Filter
Top Products
Operation: Mono Bridge Mode:
SVP1600
7 43565 15531 9
SVP1600
(21) SERIAL# BMCDN20083
Line: 120V Freq: 60 Pwr: 1.4kVA
IN
FROM PREAMP OR
EFFECT'S OUTPUT
MONO
BRIDGE
HIGH POWER
CABINET(S)
4 OHMS
MINIMUM
NOTE: THE SPEAKER CABINET(S)
MUST BE ABLE TO HANDLE THE
EXTREMELY HIGH POWER OUTPUT
OF THE MONO BRIDGED AMPLIFIER
Set the Stereo/Dual Mono / Mono Bridge switch to the Mono Bridgel position (switch in/depressed).
Connect a shielded signal cable from the Output of your Preamp or Effect to the Power Amp A Power Amp Input jack.
Connect a speaker cable from the SVP1600’s Mono Bridge Speaker Output jack to the input jack(s) of the speaker(s).
NOTE: The Speakon
®
cable must be wired as follows: 1+ = hot, 2+ = return.
Operation:
Dual Mono Mode:
SVP1600
7 43565 15531 9
SVP1600
(21) SERIAL# BMCDN20083
Line: 120V Freq: 60 Pwr: 1.4kVA
OUT
FROM PREAMP OR
EFFECT'S OUTPUT
STEREO/
DUAL MONO
CABINET(S)
2 OHMS
MINIMUM
CABINET(S)
2 OHMS
MINIMUM
Set the Stereo/Dual Mono / Mono Bridge switch to the Stereo/Dual Mono position (switch out).
Connect a shielded signal cable from the Output of your Preamp or Effect to the Power Amp A Power Amp Input jack.
Connect a speaker cable from the SVP1600’s Power Amp A Speaker Output jack to the input jack(s) of one (set) of the speakers.
Connect a speaker cable from the SVP1600’s Power Amp B Speaker Output jack to the input jack(s) of the other speaker(s).
NOTE: The Speakon
®
cable must be wired as follows: 1+ = hot, 1- = ground.
6
SVP1600 Stereo Bass Power Amplifier