Filter
Top Products
©American Audio® - www.AmericanAudio.us - DCD-PRO240™ Instruction Manual Page 17
BASIC OPERATIONS (CONT)
1) Be sure a disc is inserted in the drive and press the PROG
Button (5). Pressing the PROG Button (5) from any function
will immediately pause the disc and enter the program
mode.
2) After activating the program mode the PROGRAM INDICA-
TOR LED will begin to glow indicating Program Mode has
been activated.
11. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the
order they will be played in. You may program a maximum of 20 tracks at once and program a single track to
played more than once. To create a program:
3) Select a track to be programmed by using
the FORWARD TRACK SKIP (21) and
BACK SKIP TRACK BUTTON (20).
4) Once you reach the track you wish to place into the
program memory press PROG Button (13). Doing this will lock
the track into memory.
Figure 16
Figure 15
5) Repeat steps three and four up to 19 times (up to 20 tracks may be programmed).
6) As you program tracks into memory, the LCD (2) will indicate how many tracks have been programmed.
7) When you have finished your programming and are ready to begin
playback simply press the PLAY/PAUSE BUTTON (14) and your
program will begin to play.
8) After you have complete your program you can always add more
tracks to your program by repeating the steps one through four.
Remember that you can only a maximum of 20 track in a program
and you can only add track not subtract.
9) To cancel and clear the program press and hold down the PROG
Button(5) for more than two seconds, until the LED light turns off.
Figure 17
Figure 14