American Audio DCD PRO 250 CD Player User Manual


 
American DJ® AUDIO • DCD-PRO250™ INSTRUCTIONS MANUAL • PAGE 10
player 1 connector on transport assembly.
4) PLAYER 1 CONTROL - Connect mini-plug from
CONTROL out on rear of CONTROL UNIT to a
mixer’s CONTROL out. This feature is available on
all mixers with Fader “Q” Start (see Q” Start
Control p.5).
D. LCD (Figure 5)
1) TRACK INDICATOR - Indicates the current track
that is playing, cued, or in pause mode.
2) MINUTES INDICATOR - Display current minutes of
the track.
3) SECONDS INDICATOR - Displays the tracks
current seconds.
4) FRAME INDICATOR - Displays current track
frame.
5) BAR INDICATOR - These ten indicator provide a
FUNCTIONS & CONTROLS CONT.
visual display of the approximate position of the
pickup within the current track.
6) ELAPSED INDICATOR - It indicates that the time
shown on the display is the elapsed time.
7) CONTINUE INDICATOR - When this indicator is
glowing, disc playback will continue through the
remain tracks until the disc ends.
8) SINGLE INDICATOR - When this indicator is
glowing, playback on the current track will stop at
the beginning of the next track.
9) REMAIN INDICATOR - It indicates that the time
shown on the display is the remaining time of the
playing track.
10) PITCH PERCENTAGE DISPLAY - This displays
the amount of pitch being applied to the current
track. The pitch percentage is adjusted by the
PITCH SLIDER.
1. Opening and Closing the Disc Holder
Turn the unit power on. Press the OPEN/CLOSE button to open or close the disc tray. OPEN/
CLOSE buttons are provided on both the main unit and control unit.
• The disc holder cannot be opened during playback. This feature is to prevent playback from being
interrupted if the OPEN/CLOSE button is pressed accidentally. Stop playback first, then press the
OPEN/CLOSE button.
2. Loading discs
• Hold the disc by the edges and place it in the disc holder, then press the OPEN/CLOSE button again to
close the disc holder. The unit will show the track number and the total playing time for about 2 seconds
then enter the cue condition, the cue point will be set to the music starting point of the first track
automatically.
BASIC OPERATIONS
5 in. / 12cm disk 3 in. / 8cm disk
Fig. 8
Fig. 9