Filter
Top Products
INSTALLING THE CORRESPONDING RECEIVERS LIKE i-M15a
(here we use i-M15a for the installing procedures )
1. Turn on TR1a power LED will be lighted
2. Turn i-M15a (or other corresponding receivers) battery power ON by pressing the
POWER (Battery Power) button on top of i-M15a for 5 seconds. Once i-M15a
battery power turning ON i-M15a will be under Standby mode. (If you have power
adaptor plugged into i-M15a, the i-M15a will be under Standby mode all the time.
3. Pressing ON/OFF button on top panel of i-M15a (or POWER button on Remote
Control handset) you will turn i-M15a from Standby(OFF) mode to ON.
4. You will see Power on screen once turning i-M15a ON for the 1st time. Then i-
M15a will scan for all available TR1a and indicated on the screen how many TR1a
exist. (" 0 or 1 or 2 or 3 or .... Transmitter Exist . (Press / )" )
Remarks : When you change locations of TR1a's or i-M15a's, you should re-scan
the TR1a by pressing RESCAN button on Remote Control handset aiming at IR
receiver located besides i-M15a LED's on bottom of i-M15a front panel. Scanning
for TR1a takes around 25 ~ 40 seconds.
5. Press or button on top and bottom of "MENU" button, you will see a list of
available TR1a you can link your i-M15a to. The format of name of each available
TR1a is as following:
TR1-xxxxxx (xxxxxx is IP address of each TR1a you can find on the Barcode label
on the bottom of each TR1a. It is the last 6 digits of the number under the
barcode)
6. Use or button on top and bottom of "MENU" button you can select your
preferable TR1a you want to view the programs from. You then press ENTER on
remote control to confirm and link to the TR1a you selected.
7. You can start to enjoy programs from TR1a by using Remote Control handset
included with TR1a by selecting TV or AV1 or AV2 or S VIDEO four sources from
each TR1a.
8. If you want to select another TR1a for the i-M15a you are using, you can press
RESCAN button on Remote Control hand set and repeat above procedure to
make the choice.
9. When one i-M15a selected a TR1a and other i-M15a's want to connect to the
same TR1a, the other i-M15a's will be under LISTENING mode. And the TR1a will
be only controlled by the 1st i-M15a connected to it.
10. Scanning in TV Channels
a. Press the TV button on the remote to select between "Broadcast TV" and
"Cable TV"
12