Filter
Top Products
-
8
MAX
/
CTRL ROOM
PHONES
2TK TO
CTRL ROOM
2TK TO
CTRL ROOM
2TK TO MIX
TAPE
-
8
2TK IN
MAX
PHPWR
L
R
CLIP
10
7
4
2
0
-2
-4
-7
-10
-20
-30
+15
-
8
MAIN MIX LEVEL
OUTPUT LEVEL
11
114.8 PAN/BAL Control
Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says, BALANCE control.
You can adjust the stereo image of the signal via this control. Keep this control in center position and your signal
will be positioned in the middle of stage. Turn this control fully counterclockwise and the signal will be present only
on the left speaker and vice-versa.
In the AMX-140FX model, excluding sending out directly to the external effect or processor equipment, the AUX SEND2
will also be sent to the internal onboard effect module.
12
4.9 PEAK LED
Inside your AMX-140(FX) the audio signal is monitored in several different stages and then sent to the PEAK LED.
When this LED blinks, it warns you that you are reaching signal saturation and possible distortion. The PEAK LED will
blink with a level that is 6dB before actual clipping.
134.10 LEVEL Control
This control will adjust the overall level of this channel and set the amount of signal sent to the main output.
4.11 MAIN MIX LEVEL Dial
This control sets the amount of signal sent either
to the main out socket or to the tape output.
14
4.12 OUTPUT LEVEL LED Display
This stereo 12 segments LED meter will indicate
the level of the overall output signal.
15
4.13 POWER LED
This LED indicates when the power is on in your
AMX-140(FX).
16
4.14 PHANTOM LED
This LED indicates when the phantom power is
switched on.
17
4.15 TAPE Switches
Engaging this button to route the 2 TRACK IN signal
into the control room output.
- 2TK TO CTRL ROOM
Engaging this button to route the 2 TRACK IN signal
into the main output.
- 2TK TO MIX
18
19
14
15
16
17
18
19
20
21