Filter
Top Products
TRANSCODERS
4
APPLICATION DIAGRAM 4
INSTALLING YOUR TRANSCODER 5
Step 1. Connect the video output of the W-VHS
VCR or HDTV camera to the video input of
the TR6102HD using 3-BNC coaxial
cables.
Step 2. Connect the display device to one of the 3
output ports of the TR6102HD using the
proper cable. If display device accepts 5-
BNC input, use the 5-BNC output of the
unit and a 5-BNC to 5-BNC cable. If the
display device has a 15-pin HD connector,
use a VGA cable, and connect to one of
the two VGA outputs
Step 3. Connect the power cord and turn the unit
on. The LED lights will turn on, indicating
that the unit is operational.
Step 4. Make sure that the large screen projector
or monitor’s picture is acceptable. Make
the necessary adjustments to the W-VHS
VCR. NOTE: The converted image may
exhibit streaking on the very bottom of the
image. Use the blanking controls on the
projector to blank the two bottom lines.
CONGRATULATIONS! YOU ARE ALL DONE.
OPERATION 6
The TR6102HD will operate successfully as long as
cables are attached properly and other technical
specifications are followed.
6.1 HDTV INPUT
The input of the TR6102HD consists of 3 BNC
connectors and is directly compatible with the
output of a W-VHS VCR and a HDTV camera.
CONNECTOR CONNECTOR
TYPE
DESCRIPTION
1 BNC Ey
2 BNC EpB
3 BNC EpR
Table 4. HDTV input configuration
6.2 RGB OUTPUT
Three buffered RGB outputs are provided on the
TR6102HD. The main output is RGBSHV on 6-
BNC connectors. Output No.1 and No.2 are 15-pin
HD connectors with video signal output pin-outs
compatible with VGA pin-outs.
CONNECTOR CONNECTOR
TYPE
DESCRIPTION
1
BNC RED
2
BNC GREEN
3
BNC BLUE
4
BNC COMPOSITE SYNC
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.