Filter
Top Products
DISTRIBUTION AMPLIFIERS
6
INSTALLING YOUR DISTRIBUTION
AMPLIFIER 6
Step 1. Connect the power cord to the unit and
plug it into the power outlet. The power
indicator LED on the front panel will light.
This indicates that the unit is operational.
Step 2. Connect the audio output of the source
(computer, VCR, etc.) to the input of the
DAA0106-V0A2 using high quality cables.
The LED on the front panel will turn
green. This indicates an input signal on
the input of the distribution amplifier.
Step 3. Connect the output channels of the
amplifier to the display devices, such as
monitors or projectors.
Step 4. Verify that the quality of the output signal
on all speakers is good. If the quality of
the output signal is less than perfect,
make sure that high quality cables are
used, and all connections are solid.
CONGRATULATIONS! YOU ARE DONE.
OPERATION 7
The DAA0106-V0A2 will operate successfully as
long as cables are attached properly and other
technical specifications are followed.
7.1 TERMINATION SWITCH
The termination switch of the audio amplifier may
be set to 600 Ohms on the audio input if it is in the
ON position, and high impedance in the OFF
position.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.