Filter
Top Products
3
Total Continuous Power: 4 Watts RMS
• Drivers: 2 Watts/channel @ 8 ohms
@ 10% THD+N @ 20 Hz – 20 kHz
2 Channels Loaded
Frequency Response: 100 Hz – 20 kHz
Signal to Noise Ratio
@ 1 kHz input: > 75 dB
Drivers: Two 25 mm full-range neodymium
micro drivers and two 18 mm
neodymium tweeters
POWER REQUIREMENTS
USA, Canada and applicable
Latin American countries: 120 V AC @ 60 Hz
Europe, United Kingdom,
applicable Asian countries,
Argentina, Chile and Uruguay: 230 V AC @ 50 Hz
System Specifications
Altec Lansing’s superior sound comes from our patented technology, which utilizes custom-built, high-fidelity drivers, state-of-the-art equalization circuitry,
and a harmonious mix of the following specifications:
No Power LED lit
(AC Operation).
No Power LED
lit (Battery
Operation).
Power LED
turns amber.
No sound
from speakers.
Universal power supply cord isn’t connected to a wall
outlet and/or the power supply connector is not
plugged into the power supply jack on the back of the
inMotion system.
Surge protector (if used) isn’t powered on.
Wall outlet is not functioning.
Power isn’t turned on.
No batteries installed.
Power isn’t turned on.
Low batteries.
Power isn’t turned on.
Volume is set too low.
iPod mini is not correctly seated into the docking
station.
3.5mm stereo cable isn’t connected to audio source.
3.5mm stereo cable is connected to wrong output on
audio source.
Problem with audio source.
Plug the universal power supply into a wall outlet and plug the power supply
connector into the power supply jack.
If the universal power supply cord is plugged into a surge protector, make sure
the surge protector is switched on.
Plug another device into a wall outlet (same outlet) to confirm the outlet
is working.
Slide Power switch to “On” position.
Install (4) AA batteries into the battery compartments located on the bottom
of the inMotion iMmini system. Make sure the batteries are installed per the
illustration in the battery compartments.
Slide Power switch to “On” position.
Replace batteries.
Verify the universal power supply cord is plugged into a wall outlet and the
power supply jack.
Verify batteries are installed if the universal power supply isn’t being used.
Verify the Power button has been positioned to the “On” position and the LED
is illuminated.
Move the slider to the right to increase the volume.
Check volume level on alternate audio source device and set at mid-level.
Remove iPod mini and re-seat it in the docking station.
Connect 3.5mm stereo cable to the audio source. Make sure the signal cables
are inserted firmly into the correct jacks.
Make sure the 3.5mm stereo cable is connected and fully inserted in the “line-
out,” “audio-out,” or the headphone jack on your sound card or other audio
source.
Test the speakers on another audio source by removing the 3.5mm stereo cable
from the audio source and connecting it to the “line-out,” “audio-out” or the
headphone jack of a different audio source (e.g., portable CD, cassette player
or FM radio).
Troubleshooting
Symptom Possible Problem Solution