Filter
Top Products
4-EN
Detaching the Front Panel
1 Press and hold the SOURCE/POWER button for
more than 3 seconds to turn off the power.
2 Press the (Release) button at lower left corner
until the front panel pops out.
3 Grasp the left side of the front panel and pull it
out.
NOTES
• The front panel may become hot in normal usage
(especially the connector terminals), this is not
malfunction.
• To protect the front panel, place it in the supplied
carrying case.
Attaching the Front Panel
1 First, insert the right side of the front panel into
the main unit. Align the 2 small holes on the front
panel with the 2 projections on the main unit.
2 Push the left side of the front panel until it locks
firmly into the main unit.
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
Basic Operation
2
1
BAND
SOURCE/
POWER
g f
Initial System Start-Up
Immediately after installing or applying power to the
unit, it should be initialized. To do this, first, remove
the detachable front panel. Behind the front panel, to
the right of the connector, there is a small hole.
Using a ball-point pen or other pointed object, press
the RESET switch mounted behind this hole to
complete the initialization procedure.
Turning Power On and Off
1 Press the SOURCE/POWER button to turn on
the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c and DISP button.
Press and hold the SOURCE/POWER button for
more than 3 seconds to turn off the unit.
NOTE
The very first time the power is turned on, the unit will be
in the tuner mode at volume level 12, with BBE* or the
LOUD** function on.
* CDM-9823 only.
** CDM-9821 only.
Subwoofer On and Off
1 Press and hold the F/SETUP button for at least 3
seconds.
2 Press the g or f button to select the SUB
( Subwoofer) mode.
3 Press the BAND button to select Subwoofer ON
or OFF.
4 After setting is completed, press the F/SETUP
button to return to normal mode.
NOTES
• Initial mode is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is used.
• When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer to
the Adjusting Volume/Balance/Fader.
MODE/Rotary encoder
1
RESET switch
F/SETUPMUTE
2/02-07_CDM-9821(EN) 03.7.31, 11:27 AM4