Filter
Top Products
7-EN
01GB04CDE9873.fm
ALPINE CDE-9873 68-05946Z84-A (EN)
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press (MUTE)/RTN to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing (MUTE)/RTN again will bring the audio back
to its previous level.
Setting Time
1
Press and hold A.SEL/SETUP for at least 2 seconds
to activate the SETUP mode.
2
Turn the Rotary encoder to select the CLOCK ADJ
mode, and then press / /ENT.
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours while
the time indication is blinking.
4
When the hour has been adjusted, press / /ENT.
5
Turn the Rotary encoder to adjust the minutes
while the time indication is blinking.
6
Press and hold A.SEL/SETUP for at least 2 seconds
to return to normal mode.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold //ENT for at least 2 seconds
after setting the “hour.” Minutes will reset to “00”. If the display
shows over “30” minutes when you do this, the time will advance one
hour.
• Pressing /RTN will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Listening to Radio
1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1) F2 (FM2) AM F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode) SEEK (Local mode)
OFF (Manual mode) DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Radio
BAND
Preset buttons
(1 through 6)
TUNE/A.ME
SOURCE/
01GB00CDE9873.book Page 7 Friday, September 22, 2006 5:17 PM