Filter
Top Products
24-EN
01GB05CDE9873.fm
ALPINE CDE-9873 68-05946Z84-A (EN)
Installation
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove the Detachable Front Panel (refer to page 6).
Remove the mounting sleeve from the main unit
(see “Removal” on page 25).
Detachable Front
Panel
Less than 35°
Mounting Sleeve
(Included)
Dashboard
This unit
Pressure Plates
*
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
*
1
) already
attached to the vehicle’s chassis.
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier to
the corresponding output lead coming from the left
rear of the CDE-9873. Connect all other leads of the
CDE-9873 according to details described in the
CONNECTlONS section.
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
Screw
This unit
*
2
*
1
01GB00CDE9873.book Page 24 Friday, September 22, 2006 5:17 PM