Alpine CDA-9807 CD Player User Manual


 
5-EN
Basic Operation
SOURCE/POWER
Detaching the Front Panel
1 Press and hold the SOURCE/POWER button for more
than 3 seconds to turn off the power.
2 Press the (Release) button at upper left side until
the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
NOTES
The front panel may become hot in normal usage (especially
the connector terminals on the back of the front panel.) This is
not a malfunction.
To protect the front panel, place it in the supplied carrying
case.
Attaching the Front Panel
1 First, insert the right side of the front panel into the
main unit. Align the groove on the front panel with the
projections on the main unit.
2 Push the left side of the front panel until it locks firmly
into the main unit.
NOTES
Before attaching the front panel, make sure that there is no
dirt or dust on the connector terminals and no foreign object
between the front panel and the main unit.
Attaching the front panel carefully, holding the sides of the
front panel to avoid pushing buttons by mistake.
2
1
1
1
RESET switch
Initial System Start-Up
Be sure to press the RESET switch when using the unit
for the first time, after installing the CD changer, etc., or
after changing the car battery.
To do this, first, remove the detachable front panel. Behind
the front panel, to the right of the connector, there is a small
hole. Using a ball-point pen or other pointed object, press
the RESET switch mounted behind this hole to complete
the initialization procedure.
Turning Power On and Off
1 Press the SOURCE/POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except
the eject c and DISP/TITLE
button.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the SOURCE/POWER button for at
least 3 seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level
12.