Alliance Laundry Systems 9001889R7 Speaker User Manual


 
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
9001889
28
Calibration of the Machine
The _x__PV should reflect the size selected in earlier
steps.
Turn key to Program Mode.
Press “Auxiliary”, “3”, “1”.
The total hours the machine was running will be
displayed.
Press “Advance” and screen will show total cycles.
Press “Advance” to calibrate the water level sensor.
If the value is not zero, press “Enter” and the value
will change to zero.
Press “Advance” to calibrate the motor.
The board will lock the door and let the motor spin at
approximately 500 rpm (Firmware version 1.12 or
higher). The rpm will increase on the display. If the
machine reached approximately 500 rpm, the display
will show a reference value.
After the reference value is shown, the machine will
coast down to stop. When the machine stands still, the
board will unlock the door.
Program Cycle 00
Total working
hours : 0
level : 0.0 “
Enter to zero
Spin
XXX rpm
Reference x.xx