Filter
Top Products
3 A Tour of the Wildfire
16
accepts a 1/4” plug. Expression pedals may be
purchased at your local Alesis dealer.
AUX (Auxiliary) INPUT
The AUX INPUT allows you to play along with your
favorite songs! Just connect this RCA input to the
output from your CD player, tape player or some other
external audio device. The AUX INPUT level is fixed,
but you can use the external audio device’s own volume
control (for example, the headphone volume control on
a portable CD player) to adjust the level of the signal
coming into these jacks. When you turn the MASTER
VOLUME knob, the level of this signal is affected as
well.
STEREO LINK OUTPUT
To take full advantage of the on-board stereo effect
processor, connect the STEREO LINK OUTPUT to
the input of a second amplifier to create a true stereo
setup. This jack accepts 1/4” TS cables.
SPEAKER OUTPUT
You can use the SPEAKER OUTPUT to connect the
Wildfire to an external 8-ohm speaker with a 1/4” TS
cable. This will disconnect the internal speaker.
See chapter 9 for
detailed instructions on
how to set up a stereo
link between two
am
p
li
f
iers.
The SPEAKER
OUTPUT is high-
voltage and can easily
damage normal
recording, PA, and
other line-level input
stages, so do not
connect this output to a
recording device, a PA
system, or the input of
another Wildfire.
Connect it only to an 8-
ohm speaker.