Filter
Top Products
Troubleshooting
25
GB
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly until “MD” appears
(page 22).
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1 Disconnect the power cord.
2 Reconnect the power cord.
3 Press ?/1 to turn on the system.
4 Press x, ?/1 and turn volume to the left at
the same time.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
One of the following messages may appear or
flash in the display during operation.
CD/MP3
NO DISC
There is no disc in the player.
NO STEP
All of the programed tracks have been erased.
OVER
You have reached the end of the disc while pressing
and holding M during playback or pause.
STEP FULL
You tried to program 26 or more tracks (steps).
PUSH STOP
You pressed PLAY MODE during playback.
Tuner
COMPLETE
The preset operation ended normally.
Tape
NO TAB
You cannot record the tape because the tab has been
removed from the cassette.
NO TAPE
There is no tape in the tape deck.
Timer
SET CLOCK
You tried to select the timer with the clock not set.
PUSH SELECT
You tried to set the clock or timer during timer
operation.
SET TIMER
You tried to select the timer when Play Timer or Rec
Timer are not set.
TIME NG
Play Timer or Rec Timer start and end times are set
to the same time.
Messages
continued