Aiwa AWP-ZP5 Home Theater System User Manual


 
32
GB
Tuner
Severe hum or noise/stations cannot be
received.
Set the proper band and frequency (page 13).
Connect the antenna properly (page 8).
Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
Keep the antennas away from the system and
other components.
Consult your nearest Aiwa dealer if the supplied
AM antenna has come off the plastic stand.
Try turning off surrounding electrical equipment.
Set “CD POWER OFF” by CD power manage
function (page 14).
A stereo FM program cannot be received in
stereo.
Press FM MODE until “MONO” disappears in the
display.
Noise is heard while loading/removing a disc.
Change the location of the AM antenna.
Personal computer (except for
AWP-ZP1)
There is no sound.
Connect the personal computer properly.
Press PC (or FUNCTION repeatedly) to select
“PC” (page 26).
Select the standard audio device in the
“Multimedia” or “Sounds and Multimedia” (for
Windows 2000/Me/98 Second Edition) or
“Sounds, Speech, and Audio Devices” (for
Windows XP) on the Control Panel of the
computer.
Optional components
There is no sound.
Refer to General item “There is no sound.”
(page 30) and check the condition of the system.
Connect the component properly (page 28) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
Turn on the connected component.
Refer to the operating instructions supplied with
the connected component and start playing.
Press FUNCTION repeatedly (or MD* on the
unit) to select “MD” (page 29).
*AWP-ZP1 only
The sound is distorted.
Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
1 Disconnect the power cord.
2 Reconnect the power cord.
3 Press ?/1 to turn on the system.
4 Hold down ?/1 and then press i-Bass on the
unit for 2 seconds.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.