Aiwa AWP-ZP3 Home Theater System User Manual


 
34
GB
On operating voltage
Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.
On safety
The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
Unplug the system from the wall outlet (mains) if it
is not to be used for an extended period of time. To
disconnect the power cord (mains), pull it out by the
plug. Never pull the cord itself.
Should any solid object or liquid fall into the system,
unplug the system and have it checked by qualified
personnel before operating it any further.
AC power cord must be changed only at the qualified
service shop.
On placement
Do not place the system in an inclined position.
Do not place the system in locations where it is;
Extremely hot or cold
Dusty or dirty
Very humid
Subject to vibrations
Subject to direct sunlight.
Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.
On heat buildup
Although the system heats up during operation, this
is not a malfunction.
Place the system in a location with adequate
ventilation to prevent heat build-up in the system.
If you continuously use this system at a high volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.
To prevent a malfunction, do not cover the
ventilation hole.
In case color irregularity is observed
on nearby a TV screen
With the magnetically shielded type of speaker system,
the speakers can be installed near a TV set. However,
color irregularity may still be observed on the TV
screen depending on the type of your TV set.
If color irregularity is observed…
Turn off the TV set once, then turn it on after 15 to 30
minutes.
If color irregularity is observed
again…
Place the speakers farther away from the TV set.
On operation
If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not operate
properly. Remove the disc and leave the system
turned on for about an hour until the moisture
evaporates.
When you move the system, take out any disc.
If you have any questions or problems concerning your
system, please consult your nearest Aiwa dealer.
Additional Information
Precautions