Filter
Top Products
En
ENGLISH
15
DOLBY SURROUND AND DTS
SURROUND
ADJUSTING SPEAKER LEVEL
BALANCE
SUBWOOFER
+,-
CENTER
+,-
REAR +,-
BALANCE
BALANCE
JOG +,-
MANUAL
SELECT
The unit is equipped with a built-in test signal generator called a
noise sequencer for easy balance adjustment of all five channels.
The sequencer outputs a noise signal that “travels” from channel
to channel, enabling the simple adjustment of sound level to
achieve the same apparent loudness, at your listening position,
from each channel.
Preparation
• Before adjusting the speaker level balance, be sure to set
the speaker size, distance and existance correctly.
• Before adjusting the speaker level balance, turn off the DSP
surround system.
• Operate the unit while playing the source recorded in Dolby
Digital surround or Dolby Pro Logic.
1Turn SURROUND on.
2 Press and hold MANUAL SELECT on the remote
control until “L” of “L/R 0dB” starts to flash.
A noise signal is sent to each channel in turn at the interval of
2 seconds as follows:
L/R 0dB
C 0dB
L/R 0dB
S 0dB
S 0dB
*L or R flashes to indicate one of the front speakers from
which the noise signal is output.
3 Adjust the sound level of the center and surround
speakers.
While “C” or “S” flashes in the display, press JOG + or - on
the remote control so that the sound level of the center or
surround speakers matches that of the front speakers.
The blance of the front speakers can be adjusted as well while
“L/R” is displayed.
4 Press MANUAL SELECT again to stop the noise
signal.
NOTE
• When the noise signal cycles through all the speakers for ten
times, the noise singal stops automatically.
• When the center speaker and/or surround speakers are set to
“NONE”, their level balance cannot be adjusted. (“C 0dB” and “S
0dB” are not displayed.)
About the channels
The left and right front speakers create the stereo effect.
The center speaker helps precise sound positioning over a broad
sound field.
The surround speakers enhance the “depth” of the sound field.
CHANGING SPEAKER VOLUME
TEMPORARILY
According to the software played or your preference, you can
change the sub woofer, center speaker and surround speakers
volume temporarily.
Press SUBWOOFER +/-, CENTER +/- or REAR +/-
on the remote control.
Each speaker level can be changed within the range from –10
dB to +10 dB at 1 dB steps.
To restore the volume and balance to the default value
Press and hold BALANCE until “LVL RESET” is displayed.
All the speaker volume as well as the left and right balance of
the front and surround speakers are reset to the default value
(0 dB).
(Left front speaker)*
(Center speaker)
(Right front speaker)*
(Right surround speaker)
(Left surround speaker)