Filter
Top Products
12
ENGLISH
INSERTING BLANK SPACES
4-second blank spaces can be inserted at the desired point during
recording. (Applicable when the source is TUNER or VIDEO/
AUX/PHONO.)
1
Press wREC/REC MUTE during recording or
while in recording pause mode.
4 on the display flashes for 4 seconds and a 4-second
blank space is made. Then, the deck enters the recording
pause mode.
2
Press a to resume recording.
To insert a blank space of less than 4 seconds, press wREC/
REC MUTE again while 4 is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press wREC/REC MUTE
again. Each time the button is pressed, a 4-second blank space
is added.
To erase a recording
A previous recording is erased when a new recording is made
on that part of that tape.
1 Insert the tape to be erased into Deck 2 and press TAPE/
DECK 1/2 to display “TP2”.
2 Wind up the tape to the point where the erasure is to be
started.
3 Press wREC/REC MUTE to start the erasure.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with
adhesive tape, etc.
• 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
• Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DUBBING
s
w REC/
REC MUTE
DECK 1
SYNC DUB
DECK 2
TAPE/
DECK 1/2
Preparation
• Set the tape to the point where recording will start.
• Note that recording will be done on one side of the tape only.
1
Press TAPE/DECK 1/2.
2
Insert the original tape into Deck 1 and the tape
to be recorded on into Deck 2.
Insert the tapes with the sides to be played back or recorded
on first facing out from the unit.
3
Press TAPE/DECK 1/2 to select Deck 1.
“TP1” is displayed.
4
Press wREC/REC MUTE to start recording.
Playing and recording start simultaneously.
To stop dubbing
Press s.
DUBBING THE WHOLE TAPE
This function allows you to make exact copies of both sides of
the original tape.
NOTE
• Dubbing does not start from a point halfway in the tape.
• Note that recording will be done on one side of the tape only.
1
Press TAPE/DECK 1/2.
2
Insert the original tape into Deck 1 and the tape
to be recorded on into Deck 2.
Insert each tape with the side to be played back or recorded
on first facing out from the unit.
3
Press SYNC DUB to start recording.
“DUBBING” appears on the display.
The tapes are rewound to the beginning of the front sides,
and recording starts.
To stop dubbing
Press s.
NOTE
Recording does not start if the erasure prevention tab for the
side of the tape facing out from the unit is broken off.