Aiwa TS-W150 Speaker User Manual


 
7
En
SPECIFICATIONS
Input terminals INPUT 1 jack
INPUT 2 terminals
Input sensitivity/impedance INPUT 1:
400 mV/10 kilo ohms (at 50 Hz)
INPUT 2:
4 V/4.5 kilo ohms (L and R)
(at 50 Hz)
Output terminals SPEAKERS OUT terminals
Power output 150 W (4 ohms, T.H.D. less than 1%,
at 50 Hz to 200 Hz)
180 W (4 ohms, T.H.D. 10%,
at 100 Hz)
Frequency response 50 Hz – 200 Hz
Speaker type Bass reflex type
Speaker unit 25 cm (9
7
/8 in.)(Magnetically
shielded type)
Power requirement AC 120 V, 60 Hz
Power consumption 70 W
Dimensions (w/h/d) 320 × 378 × 447 mm
( 12
5
/8 × 15 × 17
5
/8 in.)
Weight 14.1 kg (31 lbs 1 oz.)
Specifications and external appearance are subject to change
without notice.
Phase
Depending upon the room or the characteristics of the right
and left speakers, sound from the powered subwoofer may
seem unnatural or unusually loud or soft.
In this case, try changing the PHASE switch setting. Set to the
NORMAL or REVERSE position, whichever sounds better.
BASS SOUND RANGE
You can adjust the sound range of the powered subwoofer to
complement the sound range of the other speakers.
Set the TURN OVER switch to one of the three positions.
60 Hz: Output 60 Hz and under.
100 Hz: Output 100 Hz and under.
150 Hz: Output 150 Hz and under.
AUTO POWER
Before using this function, make sure the POWER button is
set to ON.
While the AUTO POWER switch is set to ON, the power is
automatically turned on when receiving a signal input from
either INPUT 1 or INPUT 2. The power is automatically turned
off if no signal is input for a while and the indicator of the
POWER button turns off.
If input signal is too weak (e.g. at a quiet scene in a DVD
playback), this function may not work.
In such a case, set the AUTO POWER switch to OFF.