Aiwa XP-R210 CD Player User Manual


 
A
an unstable shelf
For safety
Do not attempt to disassemble the unit. Laser rays from the optical pickup are
dangerous to the eyes.
Make sure that pins or other foreign object do not get inside the player.
Take care not to drop the unit or subject it to strong shocks.
To keep dust from the pickup lens, keep the disc compartment lid closed after
use. Never touch the lens.
If you hear no sound when playing a disc, DO NOT turn the volume up high
because music could suddenly start at high volume. Turn the volume control
to the lowest level before starting playback and slowly turn it up to the desired
level.
Note on listening with the headphones
Listen at moderate volumes to avoid hearing damage.
Do not wear the headphones while driving or cycling. It may create a traffic
hazard.
You should use extreme caution or temporarily discontinue use in potentially
hazardous situations, such as walking, jogging, etc.
Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in
condensation on the pickup lens and malfunction or playback difficulties.
Should this occur, leave the unit for a few hours, then try to playback again.
USING ON DRY CELL BATTERIES A
Open the battery compartment and insert two size AA (LR6) alkaline batteries
with the 0 and 9 marks correctly aligned.
Battery replacement
OPE/BATT indicator changes from F (green) to M (orange) to E (red) according
to the remaining power of the batteries. Replace the batteries when E (red) lights.
If the unit remains in use after E (red) lights, “Lo-bAtt” appears and operation
stops.
Battery life (using alkaline batteries LR6)
Battery life may vary depending on conditions of use.
If the cover of the battery compartment comes off B
Note on dry cell batteries
Make sure that the 0 and 9 marks are correctly aligned.
Do not mix the different types of batteries, or an old battery with a new one.
• To prevent the risk of electrolyte leakage or explosions, never recharge the
batteries, apply heat to them, or take them apart.
When not using the batteries, remove them to prevent needless battery wear.
If liquid leaks from the batteries, wipe thoroughly to remove.
B
AA (LR6) × 2
The setting of the EASS switch Battery life
48 Approx. 20 hours
12 Approx. 19 hours
OFF Approx. 15 hours