Filter
Top Products
14
En
TAPE OPERATIONS
Playback
Use only type I (normal) tapes.
1
Press TAPE/DECK 1/2 and insert the tape in either
deck.
Press zPUSH EJECT to open the cassette holder, and
insert with the exposed side down and playback side
facing out from the unit. Push zPUSH EJECT to close.
PUSH EJECT
2
Press c.
To stop playback
Press s.
To pause playback (DECK 2 only)
Press a. Press again to resume.
To fast forward or rewind
Press f or g.
To select a deck (DECK 1 or DECK 2)
Press TAPE/DECK 1/2 (DECK 1/2 on the remote control) in
stop mode when tapes are loaded in both decks. The deck
number ("T1" or "T2") is displayed.
To reset the tape counter
Press s in stop mode, and the tape counter on the display is
reset to "0000". Opening and closing the cassette holder
will also reset the tape counter.
To play continuously (DECK 1 to DECK 2)
Load tapes in both decks and start playback on DECK 1. Then,
as soon as playback on DECK 1 finishes, playback on DECK
2 will start without interruption.
•The both decks play one side of the tapes.
To play back type II (High position) tapes
Turn MULTI JOG until "SOFT" is displayed while playing a
type II tape.
Then, the unit provides the optimum playback sound for type
II tapes.
Notes on cassettes
•Use of 120-minute or longer tapes is not recommended
since they are extremely thin and easily deformed or
damaged.
•Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may jam in the mechanism.
•"SOFT" sound for type II tapes described above is canceled
when the cassette holder is opened, the function is changed,
or the unit is turned off.
Basic recording
Use only type I (normal) tapes. DECK 2 is the recording deck.
Only one side of the tape can be recorded at a time.
1
Insert the recording tape in DECK 2.
Press zPUSH EJECT to open the cassette holder, and
insert with the exposed side down and the side to be
recorded on facing out from the unit.
Wind up the tape to the desired point if needed.
2
Prepare the source.
To record CD(s), select the CD function and load disc(s).
To record a radio broadcast, tune in to the desired station.
To record a tape, insert the source tape in DECK 1 and
select the TAPE function (DECK 1.)
To record from connected external equipment, select the
VIDEO/AUX function and prepare the equipment.